To Change Your IP Address With CMD

** To Change Your IP Address**
1. Click on "Start" in the bottom left hand corner of screen
2. Click on "Run"
3. Type in "cmd" and hit ok You should now be at an
MSDOS prompt screen.
4. Type "ipconfig /relse" just like that, and hit "enter"
5. Type "exit" and lve the prompt
6. Right-click on "Network Places" or "My Network Places"
on your desktop.
7. Click on "properties You should now be on a screen
with something titled "Local Ar Connection", or
something close to that, and, if you have a network
hooked up, all of your other networks.
8. Right click on "Local Ar Connection" and click
"properties"
9. Double-click on the "Internet Protocol (TCP/IP)" from
the list under the "eral" tab
10. Click on "Use the following IP address" under the
"eral" tab 11. Crte an IP address (It doesn't matter
what it is. I just type 1 and 2 until i fill the ar up).
12. Press "Tab" and it should automatically fill in the
"Subnet Mask" section with default s.
13. Hit the "Ok" button here
14. Hit the "Ok" button again
You should now be back to the "Local Ar Connection"
screen.
15. Right-click back on "Local Ar Connection" and go to
properties again.
16. Go back to the "TCP/IP" settings
17. This time, select "Obtain an IP address automatically"
tongue.gif
18. Hit "Ok"
19. Hit "Ok" again
20. You now have a new IP address With a little practice,
you can sily get this process down to 15 seconds.